Finisher 2nd Shift - 3pm-11:30pm - Fenner : Job Details

• SAFETY practices MUST be exercised by each operator at all times.
• Use safety devices and equipment provided.
• Refer to shop manual procedures and types of edge finishing.
• Finishers will set rolls on finish table, straighten spirals so they are uniform and connect panels with connecting crimp.
• Once table load is set up, confirm spirals per foot from the entry on the shop order.
• Apply tension and trim spirals.
• Square the belt.
• Weld edges of belt in accordance with type of edge required.
• Inspect belt.
• Take belt to shipping department once approved by department supervisor

Equal Opportunity Employer/Protected Veterans/Individuals with DisabilitiesThe contractor will not discharge or in any other manner discriminate against employees or applicants because they have inquired about, discussed, or disclosed their own pay or the pay of another employee or applicant. However, employees who have access to the compensation information of other employees or applicants as a part of their essential job functions cannot disclose the pay of other employees or applicants to individuals who do not otherwise have access to compensation information, unless the disclosure is (a) in response to a formal complaint or charge, (b) in furtherance of an investigation, proceeding, hearing, or action, including an investigation conducted by the employer, or (c) consistent with the contractor's legal duty to furnish information. 41 CFR 60-1.35(c)